搜索结果: 1-4 共查到“林业工程 milling”相关记录4条 . 查询时间(0.051 秒)
Cutting Performance and Wear Characteristics of Chromium Nitride Coated Tools II.The chip forming ability of worn tools in edge-grain milling of spruce
CrN coated tool chip formation tool wear up-milling
2010/3/4
To establish the cutting performance and tool wear characteristics of a cemented carbide tool with clearance faces coated with CrN (UP), edge grain surfaces of spruce were milled with a 134 mm diamete...
Monitoring of power consumption in high-speed milling
wood machining milling high-speed measurement measuring stand
2009/2/25
This paper presents the current condition of research in the field of high-speed milling at the Faculty of Forestry and Wood Technology, Mendel University of Agriculture and Forestry, Brno. The arra...
Influence of selected factors on granulometric composition of chips in plane milling of juvenile pine wood
pine wood juvenile wood mature wood plane milling granulometric analysis
2009/2/25
The use of juvenile wood has become quite frequent today. Juvenile wood differs from mature wood in its physical, mechanical and technological properties. Different properties of juvenile wood can h...
Effect of technological parameters and wood properties on cutting power in plane milling of juvenile poplar wood
poplar cutting power juvenile wood fast-growing trees
2009/2/25
This paper presents the results of experimental measurements aimed at observing the effect of technological parameters (cutting speed vc and feed speed vf ), type of wood (juvenile wood and mature w...