搜索结果: 1-7 共查到“机械工程 Automatic”相关记录7条 . 查询时间(0.062 秒)
Comparison Of Semi-Automatic And Automatic Slick Detection Algorithms For Jiyeh Power Station Oil Spill, Lebanon
Oil spill SAR
2014/4/22
After air strikes on July 14 and 15, 2006 the Jiyeh Power Station started leaking oil into the eastern Mediterranean Sea. The power station is located about 30 km south of Beirut and the slick covered...
Optimization Algorithms for Fully Automatic Optimizing Cross-cut Saw
optimizing cross-cut saw optimization optimization mode
2011/8/3
The optimization of boards by grades plays an important role in the production for cross cutting boards, and the outturn rate and utilization of boards are directly affected by the optimization result...
Shifting Rule Modification Strategy of Automatic Transmission Based on Driver-vehicle-road Environment
shifting rule modification strategy fuzzy logic control simulation
2011/8/3
Accidental or frequent shift often occurs when the shifting rule is built based on traditional two parameters (i.e., velocity and throttle), because the speed of engine varies slower than change of th...
Design of automatic vision-based inspection system for solder joint segmentation
Automatic PCB inspection Segmentation of solder joints Illumination normalization
2009/12/14
Purpose: Computer vision has been widely used in the inspection of electronic components. This paper proposes a computer vision system for the automatic detection, localisation, and segmentation of so...
Automatic Control of Electrodes in Lithotripsy Machine
Automatic Control Electrodes Lithotripsy Machine
2010/1/15
Automatic Control of Electrodes in Lithotripsy Machine.
含复铰连杆机构的拓扑表示与其回路自动分析（Topological Representation and Automatic Kinematic Loop Analysis for Linkages with Multiple Joints）
平面连杆机构 运动链 复合铰链
2009/5/22
提出用“复合铰链零错位”分析机构结构的方法。先将复合铰链错位成相互距离为零的运动副，建立拓扑图和对应的关联矩阵，确定树及余树，通过矩阵计算求出基本回路矩阵，并进而求出完全回路矩阵。将错位的复合铰链重新合并，根据回路的权排序，再按回路的相互独立性和回路连通性找出优选的独立回路。研究表明，复合铰链零错位后绘制的拓扑图简洁、直观，关联矩阵的建立以及分析回路的算法通用，便于应用在计算机自动结构分析与运动分...
Film Thickness Analysis for EHL Contacts under Steady-State and Transient Conditions by Automatic Digital Image Processing
EHL Contacts Steady-State Transient Conditions Automatic Digital Image
2008/10/21
The knowledge of the film thickness values is very important in lubricated contacts to verify the lubrication conditions. Optical interferometry is one of the most used methodologies for film thicknes...